Toyota 1997 Avalon, Owner'S Manual

Page: 102 / 226

94
SCAN (for radio)
Types 1-2 and 1-3
You can either scan all the frequencies on
a band or scan only the preset stations for
that band.
To scan the preset stations: Quickly push
and release “SCAN”. If you hear a beep,
you held the button too long, and the radio
will scan all the frequencies. The radio will
tune in the next preset station up the
band, stay there for a few seconds, and
then move to the next preset station. To
select a station, push “SCAN” a second
time.
To scan all the frequencies: Push “SCAN”
until you hear a beep. The radio will find
the next station up the station band, stay
there for a few seconds, and then scan
again. To select a station, push “SCAN” a
second time.
SCAN (for cassette player)
Type 1-3 only
The cassette player scan feature is similar
to the radio scan feature and uses the
same button.
Push “SCAN”. “SCAN” will appear on the
display. The player will fast forward to the
next cassette track, play it for 12 seconds,
and then scan again. To select a track,
push “SCAN” a second time. If the player
reaches the end of one side of a cassette
tape, it will continue scanning on the other
side.
SKIP
Type 1-3 only
The skip feature allows you to fast forward
past long stretches off blank tape. This is
especially useful at the end of cassettes.
Push “SKIP”. SKIP” will appear on the dis-
play. The cassette player will keep track of
how much blank space it plays. Any time
it has played about 10 seconds of blank
tape, it will automatically fast forward to
the next track and begin to play.
Push the button a second time to turn off
the skip feature.
ST (Stereo reception) display
Your radio automatically changes to ste-
reo reception when a stereo broadcast is
received. “ST” appears on the display. If
the signal becomes weak, the radio re-
duces the amount of channel separation
to prevent the weak signal from creating
noise. If the signal becomes extremely
weak, the radio switches from stereo to
mono reception.
TAPE
Push “TAPE” to switch from radio opera-
tion to cassette operation. If the audio
system is off, you can turn on the cassette
player by pushing “TAPE”. In both cases,
a cassette must already be loaded in the
player.
TREB (Treble)
This knob lets you adjust treble level.
Push “BASS/TREB” so that it pops out of
its retracted position. Pull out the knob.
Turn the knob to adjust the treble. Push
the knob back into its retracted position.