BEFORE IGNITION
1.
Open the Valve(s)
Open the valve(s) of the external fuel tank.
2.
Start the Fuel flow
If using heater for the first time, or after heater has been out of fuel, press
the red reset button once for a period of one second in order to send fuel
to the fuel sump.
Note:
Make sure there is no fuel leakage from the fuel line or joints.
Also make sure fuel tank is not too high. See installation instructions.
3.
Plug in the Heater
Plug heater into a 120V AC electrical outlet. On digital indicator pre-set
“Two Dashes” will be showing.
Note:
Do not connect to an outlet shared with other appliances.
4.
Set Clock
Important: Clock on the heater must always be set to current time.
Press “HOUR” and “MIN” button to correct time.
Note:
“HOUR” or “MIN” button will change the time every one (1) unit.
Holding the button continuously will cause the time to change rapidly.
Note:
In the event of a power failure (more than approx. 20 min.) all clock and timer setting are can-
celled.
OPERATION
MANUAL OPERATION
Operation of the heater is under the direct control of the user. Heat output will, however, be automatically
adjusted in accordance with the room temperature registered by the temperature sensor.
8
SECTION E:
OPERATION
Reset button
Summary of Contents for Laser 30
Page 30: ...30 ...
