5056.4252155D
The gas control system is located on the right hand side of the fi rebox behind an access panel and the decorative fi rebox panel (if
installed). The fi replace is operated via a wall control and a hand held remote control unit.
The wall control is connected to the fi replace by a 40 ft. communication cable supplied with the fi replace.
Electrical
Note: Installation must be performed by a qulaifi ed
installer, service agency or gas supplier.
Installation
1. Place the fi replace in the desired location.
2. Remove the window from the fi replace.
3. Remove access panel from right hand side of the fi rebox (Figure 22).
Lintel knock outs
There are six knock outs on top of the lintel. These
knock outs should remain in place and not knocked
out during installation. The knock outs are for a future
optional “TV KIT” which will allow a television to be
mounted above the fi replace while having the heat
from the fi replace re-directed to a vent which will be
located above the TV.
This fi replace is designed to fi nish either
fl ush with the facing material or can be
installed with a 4 1/2 inch recess, See
“Figure 12: TCWS54D Reccessed installation
details.” on page 10.
The fi replace can accommodate facing
material thickness from 1/2 of an inch to 2
1/4 inches if installing fl ush.
Care should be taken to correctly determine
the facing material thickness so that the
fi replace is positioned so that the front of the
fi replace is fl ush with the facing material.
Facing material must not interfere with the
ability for the door or the screen to open.
Fireplace Facing Allowance
Figure 20: Knock outs for future TV Kit feature.
NON-COMBUSTIBLE
FINISH MATERIAL
NON-COMBUSTIBLE
BUILDING MATERIAL MAY NOT
EXTEND PAST THIS POINT
SCREEN
DOOR
Figure 21: Facing edge location.
14
TCWS54_D 150817-40
