1.
If installed remove the rocks and sand
from the burners.
2.
If installed remove the burner tray from
the manifold brackets and pilot.
(Fig.
#19)
3. Remove
burners
4.
Using a 1/2” wrench, undo the
natural gas burner orifi ce,
(marked
#40
). Apply a small amount
of pipe joint compound to the threads
of the propane burner orifi ce
(marked
1.45mm
) to ensure a good
seal, before screwing it into the fi tting.
Loosen the primary air shutter screw,
open shutter to give a gap of 1/8”
(0.125”) and re-tighten. Repeat on
other burner (Fig. #21).
5.
With a 7/16” wrench loosen the pilot
head on the pilot assembly. (Fig. #22)
TCWS.38NG08C 250512-16
WARNING
This conversion kit
shall be installed by a
qualifi ed service agency
in accordance with the
manufacturer's instructions
and all applicable codes
and requirements of
the authority having
jurisdiction.
If the information in these
instructions is not followed
exactly, a fi re, explosion
or production of carbon
monoxide may result
causing property damage,
personal injury or loss of
life.
The qualifi ed service
agency is responsible for
the proper installation of
this kit.
The installation is not
proper and complete
until the operation of the
converted appliance is
checked as specifi ed in the
manufacturer's instructions
supplied with the kit.
If the unit is to be used on propane
convert as follows using the compo-
nents supplied with this burner:
CAUTION
The gas supply and electrical power
shall be shut off before proceeding
with the conversion.
CAUTION
:
Factory supplied components must be
used to ensure correct input. After conver-
sion confi rm proper manifold pressure
.
CONVERSION LABEL (5052.52087)
MINIMUM RATE SCREW (5005.016)
MAIN BURNER
(1.45mm) ORIFICES (5022.8)
PROPANE CONVERSION KIT
Fig #20
Fig #22
Fig #19
Fig #21
Fig #18
7
Propane Conversion
