Ember Material Placement
LOG
GRATE
GLOWING EMBERS
4
TC36_ng06D2_130616-12
Fig. # 6
Ember Material
A large bag of ember material is shipped with the fireplace and needs to be installed on
the burner to ensure optimum performance and flame appearance.
1. Pull apart the material into ember size pieces (approximately 1” squares) and
gently place them into the burner pan. Do not compress, leave them loose for best
performance.
2.
Fill the burner pan level with the top of the pan at rear, and gradually sloping forward
down to the firebox floor at the front, covering both burner tubes.
3. Place remaining ember material outside of the burner pan as desired to cover-up gas
lines and brackets.
Note:
Ember material placement and amount will affect flame appearance. More
ember material results in lower flame height. Add or remove as needed until
desired flame affect.
Summary of Contents for TC36.NG06.D2
Page 11: ...11 TC36_ng06D2_130616 12 ...
