Fig. # 3
INTERFACE
MODULE
IGNITION
WIRE (RED)
FLAME SENSOR
WIRE (WHITE)
3
TC36_ng06D2_130616-12
1. Attach the burner assembly to the floor of
the firebox with two screws. (Fig. # 1)
2. Attach the manifold supply tube to the
bulk head fitting and tighten. (Fig. # 2)
Ensure that there are no leaks.
3. Attach the pilot supply tube to the bulk
head fitting and tighten. (Fig. # 3) Ensure
there are no leaks.
4. Attach the ignition and sensor wires to
the module. (Fig.#4).
A panel set must now be installed. See
Installation and Operating Instructions
manual for details.
5. Position the grate over the burner tray
and attach to the floor with two screws
through holes located behind the front
legs of the grate. (Fig. # 5)
Fig. # 2
Fig. # 1
Fig. # 5
Fig. # 4
Burner/ Grate Installation
BURNER TRAY INSTALLATION
GRATE INSTALLATION
Summary of Contents for TC36.NG06.D2
Page 11: ...11 TC36_ng06D2_130616 12 ...
