Advanced Setting 6: Backlight Brightness
Select “Backlight Set” to adjust the brightness of the display. The range for this setting is 1-3,
with 3 being the brightest. The default value is 2.
To change the backlight brightness settings, press the
UP
or
DOWN
button to select the
desired value. Press the
MODE
button to save the selection and return to the advanced
settings page.
Advanced Setting 7: Start Up Password
The Start Up password is different than the password used to access the general settings
menu. When enabled, the start up password will be required each time the eBike is powered
on. Select “Password Set” to enable a start up password.
The default start up password is 1212
To change the start up password, select “enable” and press
MODE
to confirm the
selection.
Enter the new start up password (P3:XXXX), using the
UP
and
DOWN
buttons.
Press
MODE
to confirm the selection and return to the advanced settings menu.
Follow the same steps to disable the startup password. Note that the P2 password will
no longer be the default value of 1212.
Additional Settings Operations
● To exit the settings menu, hold the
DOWN
button for two seconds.
● If there are not any operations for one minute, the display will exit the settings menu
automatically.
Recover Default Settings
To reset the controller to default factory settings, press both the
UP
and
MODE
buttons for 2
seconds. This will open the dEF settings (Default Recovery). Press the
UP
or
DOWN
button to
select Y/N (yes/no). Hilight “Y”, then press the
MODE
button for two seconds to recover default
settings. Note that this action will also reset the startup password to the default (1212).
8
