Tower Hobbies CERAGLIDE T22021, Instruction Manual

Page: 6 / 12

6
Before First Use:
NOTE: Every effort has been made to ensure this item reaches you in perfect condition.
However, due to our rigorous testing and quality processes before the iron leaves our production
facility, there may be a small amount of water residue left in the water tank.
This is nothing to worry about and the product can be used as normal.
You can run a clean cycle (see self clean section) if necessary to remove.
1. Remove the appliance from the packaging and check for any visible damage to the appliance,
cord and plug.
2. Remove any stickers, protective foil or storage cover from the soleplate.
3. Dispose of the packaging in a responsible manner.
Filling the tank with water:
Caution! Before filling the tank with water make sure the appliance is unplugged
1. Set the steam control to the O position in order to prevent water leakage.
2. Fill the filling cup with water. Hold the iron in a tilted position and pour the water into the
water tank to the maximum level.
3. Fill the iron with normal tap water when using it for the first time.
4. For refilling, you can also use tap water. However, if the water is very hard, it is advisable to use
distilled water.
5. Do not put vinegar, starch, chemically de-scaled water or de-scaling agents in the water
reservoir.
Setting the temperature:
1. Stand the iron on its end.
2. Insert the mains plug into the wall socket.
3. Set the temperature control to the correct ironing temperature.
4. Once the temperature light has gone out and come on again, you may start ironing.
5. The temperature light will come on from time to time during ironing.
6. When setting the temperature control to a lower setting after ironing at a high temperature,
please allow time for the iron to cool, to prevent scorching on your garment.
Spray Function:
• Press the spray button at any time to spray water on clothes.
Note: Ensure that there is enough water in the tank to use the spray function. During first use, you
may have to pump the spray button several times to start the spraying function.
Using the steam jet:
1. This function provides an extra amount of steam to remove stubborn creases.
2. Turn the temperature control to the “MAX” position. The indicator light will turn off when the
required temperature is reached.
3. Press the steam jet button once.
4. Wait for a few seconds, then press the steam jet button again.
5. Most creases can be removed with three bursts of the steam jet.
Steam-ironing:
1. Ensure that there is enough water in the water tank.
2. Set the required temperature.
Caution! Water may leak from the soleplate if too low of a temperature has been selected.
3. Once the required temperature has been reached the power indicator light will turn off.
4. Increase the steam output by pulling the steam button backwards, or decrease it by pushing
the steam button forward.