tousek Rollco LWS125/X, Installation Manual

Page: 7 / 12

tousek / E_ LWS-125/X_X40801104 / 22. 05. 2018
- 7 -
2b. Mounting of rolling gear (rollers)
Mounting
• Put up the 2 rolling gears and base plates according to the
drawing and following Em measure. Put the rolling gears
in-line with the planned gate axis and mark the drill holes.
Important
• The support length Em may not be lower than given
in the table (p. 5)
• Respect the accurate to side alignment of rolling
gears (see pict.)
• For installation the upper parts of the rollers must be unbolted from the lower plates. The ground plates have to placed ac-
cording to the measure Em and aligned to gate axis. Then assign/draw bore holes for heavy load anchor bolts.
30
• draw the bore holes. After drilling blow out holes and insert
anchor plugs.
Please use only heavy load anchors.
• now mount the two ground plates with anchor bolts.
• place the upper parts of rollers and fix them with nuts in
middle position of sloted holes
(L1–L4).
• now slide the cantilever track with the gate onto the rolling
gears. If necessary it is possible to make readjustments
(height adjustment or adjustment in sloted holes L1–L4 ).
Important
• As the rollers do not guarantee a vertical gate
guidance please ensure that appropriate guidance
brackets are included on site.
2c. Befestigung der Endplatten
Montage
Important
• before mounting the end plates please provide
rust protection on the cut surface as they are not
galvanised when leaving factory.
• loosen the clamp bolt (K) of end plates and then insert the
end plates into the track. We also suggest to fix the end
plates with two side bolts.
K
Important
• the cantilever track opens slightly at the ends when coming out of factory. When tightening the side bolts the track
profile will be tighten together.
This additional fixing is absolutely essential when using the end plates also as
limit stops!
L1 L2
L3 L4
aluminium plate
guide in bracket
gate axis
180
Em
90
325
Em DL
325
Anchor M12-50/145 (M12 x 145)
bore hole
depth
Ø hole nut torque
120mm 12mm 50Nm