Basic Installation Steps . . . cont.
(Indoor or Outdoor Greens)
8
Floating Cup Washer
(A2-DW)
Floating Cup Washer
(A2-DW)
Hole Filler [installed]
(A2-CFPA)
With the floating cups installed, apply the supplied double sided tape to the indent in the panel that will receive the
floating cup washer.
Do not apply the tape to any part of the floating cup assembly.
(If your green will be in-
stalled temporarily, taping the floating cup washers to the panel is not necessary) Position the floating cup washers
in the indent and secure to the tape, as shown in Fig. 6. Note also in Fig. 6 that the hole fillers are installed.
Affixing the perimeter panels to one another with the self tapping lag screws is the final base construction step.
Backyard Golf recommends a single screw in each outermost perimeter panel screw hole with the exception that
all holes in each inside radius panel (P2-IRSCE) be filled, as indicated in Fig. 6. At this juncture, do not tighten
the screws completely! Tightening will be done after the turf has been laid on the base.
Figure 6
ATTENTION
Panel layout shown in Fig. 6 is for illustrative purposes
only. Your green may or may not have a similar panel
layout. To build your green use the
“
Plastic Base
Construction Schematic
” shown in Fig. 1 on page 4.
Self tapping lag screws
(or other appropriate
fastener) here.
ATTENTION
For clarity, all fastener locations are not
indicated.
Self tapping lag screws
(or other appropriate
fastener) here.
