BD4603
13
TDS-G200VLDB
8. Replace the abrasive wheel, outer wheel flange
and arbor hex nut.
NOTE:
The left hand arbor hex nut is left hand threaded
and is tightened by rotating it counter-clockwise. The
right hand arbor hex nut is right hand threaded and is
tightened by rotating it clockwise.
DO NOT OVER TIGHTEN
the arbor hex nut as this
may damage the abrasive wheel, wheel flanges and
cause serious injury to the operator.
9. Replace the wheel cover and secure it back in
place on the grinder with the fasteners that were
previously removed (step 4).
10. Run the new wheel at full speed for a few minutes
to ensure that it is rotating properly.
CAUTION
!
WIRE WHEEL or BUFFING WHEEL (Fig. L)
FIG. L
A wire wheel (A) or buffing wheel (not included) can
be used with your grinder.
Depending on the thickness of the wheel, you will
need to add one or more spacers (not included) to
allow the arbor hex nut (D) to tighten correctly. Figure
L shows the correct placement of the spacer (B).
NOTE: Spacers (B) should always go onto the
arbor shaft first. Always use the wheel flanges
(E) that come with the grinder for both wire
wheel and buffing wheels. See section CHANGING
THE GRINDING WHEEL for correct procedure
of changing wheels.
OPERA
TION
