Virtuo Floor Stand Guide
Installing the Virtuo Floor Stand
Installing the crossover box
30
Installing the crossover box
1.
In the Virtuo, disconnect the audio CAT-5 cables from the I/O board Zones 1 and 2.
2.
Loosen the two lower screws from the I/O board enclosure.
3.
Insert the crossover bracket under the I/O board screws and fasten the lower left corner with the M4 screw
(included in the kit).
4.
Tighten the I/O board screws.
5.
Install the replacement warning label under the Virtuo mounting slot (included in the kit).
6.
Attach the 7 inch CAT-5 cable (included in the kit) to Zone 1 of the I/O board and to the input of the crossover.
7.
Attach the audio CAT-5 cables according to the diagram shown in
Connecting the audio cables to the Virtuo
.
I/O Board
Summary of Contents for Virtuo Floor Stand
Page 1: ...Floor Stand Guide...
Page 4: ...4...
Page 40: ...Virtuo Floor Stand Guide Installing the Virtuo Floor Stand Powering up the Virtuo 40...
Page 42: ......
