TouchTunes Virtuo Floor Stand, Manual

Page: 14 / 42

Virtuo Floor Stand Guide
Installing the Virtuo Floor Stand
List of Floor Stand components
14
To check that you have all Virtuo Floor Stand components
1. Verify that you have received these hardware components for Virtuo:
2. Open the Parts kit and verify that it contains these components:
3. Check the condition of the hardware components and parts kit items to ensure they are in good condition.
Component
Quantity Component
Description TouchTunes
Part Number
1 Floor Stand 700275-100
1 Integrated subwoofer 500w 700280-xxx
1 DA-415 4 channel amplifier 700039-154
2 Array speakers 150w 700283-xxx
1 Crossover box 700282-001
1 right base plate 400933-001
1 left base plate 400934-001
Component
Quantity Component
Description TouchTunes
Part Number
8 wing screws for Floor Stand 1/4-20 x 2 1/2, zinc plated
4 are attached to the Floor Stand 200099-040
8 washers, flat, no.10, zinc plated, to be used with 200099-040
4 are attached to the Floor Stand 200134-001
2 brackets for baseplates length 2-3/8 x width 3-23/32 x thickness 0.097,
galvanized steel 400951-001
8 screws for the baseplates Phillips, truss head, 1/4-20 x 1/2, zinc plated 200125-008
2 speaker wire, HAR, 18AWG speaker wire, 48" for array speakers 300703-048
1 18AWG speaker wire, 72” for subwoofer 300704-072
6 HWR, dome plug, 3/8", black nylon to plug holes if array speakers
not installed 400953-006
6 FAS, SCR, X-PAN,10-24x1/2,ZN for wall bracket installation 200128-008
2 36’ CAT-5 harness 300142-036
1 power cable for amplifier, HAR, A/C Power Cord 72" 300180-072
2 Euroblock connectors, ECP, EURO TERM BLOCK CONN, 4-PIN 100000-001
1 Virtuo Floor Stand Guide (this manual) 900579-001
Rev 04
CAUTION: Do not attempt installation if any hardware component or item in the parts kit is
damaged. Contact your distributor or TouchTunes to report the damage immediately and
request replacement parts.