4
PhotoBooth Camera Bracket Installation and Alignment
Installing the PhotoBooth Camera Bracket
8. Attach the camera board to the new bracket, fastening them together with the two white nylon standoffs in your kit.
Use only 2lbf-in of torque to screw in the standoffs.
The new bracket, connected to the camera board by two small white nylon standoffs
9. Insert the 16mm screw in your kit into the bracket, screwing it only a few rotations.
10. Place the two washers included with your kit over the screws protruding from the rear panel of the monitor.
11. Mount the camera assembly to the rear panel of the monitor, ensuring proper orientation (as in the diagram below, the
small PCB cable should be to the right of the PhotoBooth camera).
12. Use the 4-inch tie wrap in your kit to replace the strain relief cable you removed in step 5.
