10
PhotoBooth Camera Bracket Installation and Alignment
Aligning the PhotoBooth Camera
6. Turn the set screw (M3x16 Phillips
Pan) clockwise on the rear of the
bracket until you see the 47 inch
mark from the floor (plus or minus
half an inch) at the bottom of the
preview area.
Turning this screw bends a small
metal plate which may not rebound
if you pass the 47-inch mark and
bend it excessively.
Therefore, turn the set screw no
more than half turn at a time, then
check the Preview screen. Do not
use a motorized screwdriver.
