Connecting the DMX System to TouchTunes Digital Jukeboxes
15
7. Connect the RJ45 end of the cable to the
DMX Out
connector on the Allegro’s control board.
8. Route the free end of the cable into the jukebox through the cable channel and then pass it
through the opening underneath the wire-relief strain bracket.
9. Connect the free end of the cable to the DMX input connector of your lighting console.
Ovation Model
The Ovation is designed with a cable channel that allows you to route outside cables to internal
jukebox components. A wire-strain relief bracket provides slack for cables inside the jukebox
and also covers the opening to the cable channel to keep dust out. In the following procedure,
adjust this bracket to access the opening to the cable channel.
Note:
Only route cables into and out of the jukebox through the provided cable channel
opening. Do not route cables through any other openings in the jukebox, such as air vents.
Otherwise, the jukebox may overheat and shut itself down.
To prepare for cable routing in the jukebox:
1. Identify the following components for the Ovation:
• The cable channel along the back of the jukebox.
• The wire-strain relief bracket shown in the following diagram.