4 of 6
4. Align the holes on the service light board with the 4 PCB board supports and press it onto the supports until the service
light board is firmly seated on all 4 PCB board supports.
Figure 5 Mounting the Service Light Board
Important:
The service light board must be properly seated on the PCB board supports, otherwise cross-talk between the
LED and photo transistor may occur, hampering the operation of the service light kit.
Cross-section Showing Proper Installation
5. Locate the small power connector from the squid cable and connect it to the 3-pin J4 power connector on the service
light board.
Figure 6 Connecting Power From Wiring Harness
Light board
Cross member
on cabinet
J4
