Product specification subject to change without prior notice.
Page 29/41
4
Cleaning the Monitor
1. Make sure the monitor is turned off.
2. Never spray or pour any liquid directly onto the screen or case (depends on different model).
3. Do not use chemical solvents, alcohol, or any other based to clean the unit or panel. It may cause
permanent damage on the unit or panel.
4. Use a clean, soft, lint-free cloth, or apply a small amount of non-ammonia, non-alcohol based glass
cleanser to achieve maximum cleaning.
5
Disclaimer
The manufacturer assumes no responsibility, and will not be liable of any damage resulting from
non-conforming safety actions or operation, or, cleaning on this product.
The standard of all panels would be followed by the ISO 13406-2 Class II.
6
Trouble Shooting
Before calling for service, please try following easy and simple steps to verify:
6.1
No picture
6.1.1
Check if the signal cable is firmly seated in the socket.
6.1.2
Check if the Power is ON at the computer
6.1.3
Check if the brightness control is at the appropriate position, not at the minimum.
6.1.4
State the monitor is powered on and the LED of power is GREEN, plug out the VGA cable
and plug in again.
6.2
The screen is not synchronized
6.2.1
Check the LED light if it indicates in red, the device is in power off status. Use the remote
and press “Power” to turn the power on.
6.2.2
Use the “Auto” key on remote control to automatically adjust the monitor timing scan.
6.2.3
Check if the signal cable is firmly seated in the socket.
6.2.4
Make sure the signal timings of the computer system are within the specification of the
monitor.
6.2.5
If your computer was working with a CRT monitor, you should check the current signal
timing and turn off your computer before you connect the VGA Cable to this monitor.
6.3
The picture is not centered
6.3.1
Adjust the H-position, and V-position, or perform the Auto adjustment.
6.4
The screen is flickering
6.4.1
Press the “Auto” - adjustment control by remote control or OSD to adjust. Re-locate nearby
devices, such as motor, or transformer, which generate magnetic field, away from the
monitor. Check if the specific voltage is applied.
