Document Number: 6500493 Rev. 1.1
Pg. 11
6.0 Touch Screen Tails
(Continued)
6.1 Connecting the Tails to the Controller
1.
To connect the Projected Capacitive Touch Screen tails to the controller, first pull out the connector
clips on the control board, as indicated by the red arrows in Figure 12(a). After the clips have been
pulled out, insert the sensor tails with the exposed copper wiring on top, as indicated by the blue arrows.
2.
Once the sensor tails have been fully inserted into the connectors, close the connector clips to secure the
sensor tails in place. Figure 12(b) illustrates this step.
Figure 12(a): Step 1
Figure 12(b): Step 2