Totoku LV32P1, User Manual

Page: 20 / 56

- 8 -
ENGLISH
• Another graphics card including the on-board VGA is conflicting.
• The display is not connected to DVI Connector A on this card.
Can I reinstall the display driver by overwriting?
No. Make sure to uninstall an existing driver before updating it or when adding/
removing cards, or changing slots, and reinstall it.
(Prior to driver installation) The Windows startup screen doesn't look right: it is plain
white screen or it shows horizontal misalignment.
Restart the computer in VGA mode.
The new graphics card doesn't get recognized as new hardware.
Check for the followings:
• The graphics card is not inserted all the way in the slot.
• The display driver may be installed already. Uninstall the existing driver before
installing the latest one.
• Another graphics card may be conflicting. Remove it to see if the problem resolves.
• Check Device Manager. If the Other devices section shows "[!] Video Controller (VGA
compatible)," the graphics card is detected. Install it from there.
• Windows NT does not detect new hardware by plug-and-play.
I can't install the display driver because the graphics card doesn’t get recognized.
Confirm that the card is inserted all the way in the slot. Make sure the card and/or the
display driver is correct. If another graphics card coexists, remove it.
I can't install the display driver when another graphics card is installed.
Remove another card once, insert this card (2 cards max.), install and set up the
display driver. Now remove this card, insert another card in another slot, install and
set up a display driver. Put this card back into the slot where it was inserted.
My computer freezes at the Windows startup screen when restarting after the driver is
installed.
This happens when another graphics card coexists. Remove another card once, insert
this card (2 cards max.), install and set up the display driver. Now remove this card,
insert another card in another slot, install and set up a display driver. Put this card
back into the slot where it was inserted.
The screen blanks out at the Windows startup screen when restarting after the driver
is installed.
This happens when the old driver (Ver. 1.4.x.x) is used on LV32P1 (Rev. E and later)
or LV52P1 (Rev. D). Use a driver version 1.5.x.x or later.
My computer freezes at the Windows startup screen when I try to add another card
after setting up this card.
Remove this card once. Insert another card in another slot, install and set up a driver
for it, and put this card back into the slot where it was inserted.
The display goes blank momentarily during driver installation.
Wait for a while.