10
11
Operational Precautions
■
For prevention of damage
●
Wipe plastic areas such as the
main unit and remote control with
a soft cloth tightly wrung out with
water.
Dry cloth or tissue
●
Do not lean against the toilet lid.
■
Problem Prevention
●
Disconnect the power plug if there is a risk of lightning.
Switch the breaker on the distribution board to OFF.
(Electrical box type, Concealed power connection type)
●
A toilet seat cover or a toilet lid cover cannot be used.
(The seat switch may not function properly.)
Covers
●
Do not urinate on the main unit, toilet seat or wand.
(Doing so may cause pink or brown stains or a malfunction.)
●
Do not apply strong forces to the control panel of the remote control.
●
When using a toilet cleaner to clean the toilet, wash it off
within 3 minutes and leave the toilet seat and toilet lid open.
Wipe off any cleaner that remains on the toilet bowl.
(If vapor from a toilet bowl cleaner enters the main unit, it
may cause a malfunction.)
●
Do not use the product with the toilet lid removed.
●
Do not expose to direct sunlight.
(Doing so may cause changes in color, irregular heated
seat temperature, remote control malfunction or Washlet
malfunction due to the change in temperature.)
●
Use radios, etc. away from the Washlet.
(The Washlet could cause interference with the radio signal.)
●
If you use a booster seat for infants or a soft highchair,
remove it after use. (Keeping it installed may prevent
some of the functions from being used.)
●
Do not apply force to the remote control. (May cause malfunction.)
To prevent the remote control from being dropped, set it in the hanger
when you are not using it. Be careful not to expose it to water.
●
Do not place anything on the toilet seat and lid, and do
not press them with hands.
Failure to do so may turn on the seat switch, causing the
fl
oor to get wet if buttons on the remote control are touched
and warm water comes out from the wand. (The seat switch
may turn on if force is applied to the toilet seat or lid.)
About rear cleansing, rear soft cleansing and front cleansing
These functions wash away waste and dirt from
a localized area of your body.
Do not cleanse too much or for too long.
Doing so may wash away normal bacteria, upsetting
the balance of bacteria inside your body.
People who are receiving medical treatment or
therapy in this localized area should consult
their doctor before use.
■
For prevention of malfunctions
●
Do not block the remote control transmitter or receiver.
< About the seat switch >
●
When you sit on the toilet seat, the seat switch turns
ON, enabling you to use various features.
(A click sound is heard when the seat switch is ACTIVATED.)
Gap
The toilet seat lowers.
Switch
ON
Seat switch
(Built-in)
●
Sit back on the toilet seat.
The seat switch will not turn on unless you sit
on the seat properly.
Note
When a child uses the Washlet, the seat switch
may not be ACTIVATED by their light body weight.
Since the toilet seat is designed to move up
and down, a clearance is provided between the
toilet seat cushion and the toilet bowl.
Safety Precautions
(Continued)
CAUTION
If a water leak should occur, always close the shutoff valve.
When the ambient temperature is likely to drop to 0°C or lower, prevent
damage to the pipes and hoses due to freezing.
Frozen water pipes could cause the main unit and the pipes to break, resulting in a water leak.
Regulate the room temperature to prevent the pipes and hoses from freezing during cold months.
Drain the water.
When not using the Washlet over an extended period of time, drain the
water out of the main unit and the water supply hose after closing the water
shutoff valve, and pull the electrical plug from the outlet.
Switch the breaker on the distribution board to OFF.
(Electrical box type, Concealed power
connection type)
When using the product again, allow the product to re
fi
ll with water
fi
rst. Otherwise, the water in
the tank might become contaminated and cause skin in
fl
ammation or other problems.
(Refer to Page 39 for instructions on replenishing the water.)
Leaving the power on may cause
fi
re or heat.
When installing the water
fi
lter drain valve, make sure that it is securely
tightened in its proper position.
Failure to securely tighten it may cause a water leaks.
Introduction
