What to Do?
Long Periods of Disuse
CAUTION
Troubleshooting
Shutoff valve
If the toilet is in a location you will not visit for a long time, drain the water.
(Failure to do so may cause breakdown or skin irritation due to polluted product tank water.)
Resupplying the Water
How to drain the water
1
■
If water may get frozen
• Add antifreeze solution to the water in the bowl to
prevent freezing.
(The antifreeze solution should not be
fl
ushed out.
Collect it before using the toilet and dispose of it.)
■
To use the product again
• The water needs to be resupplied. (See below)
2
If the power is not on,
Insert the power plug.
• The "Power" LED illuminates.
3
Discharge water from the wand.
(1) Pressing down the right side of the toilet seat,
(2) Press "Rear washing" button on the control panel to discharge water
from the wand for about 2 minutes.
• It takes about 1 minute maximum before water comes out.
• Catch the water in a paper cup or other receptacle.
(3) Press the "Stop" button on the control panel.
1
Open the shutoff valve.
• Check that water is not leaking from a pipe or the main unit.
4
Drain the pipe. (Page 35 Step
5
)
■
If the remaining water has frozen and no water comes out
• Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth soaked in warm water.
Tighten the water drain plug
securely with a
fl
at-head
screwdriver.
6
Drain the water from the toilet tank.
(Page 35 Step
1
2
)
Unplug the power plug.
3
Water drain plug
Flat-head screwdriver
■
While the LED is illuminated, energy saver
(Pages 20,
21)
is in operation, so the toilet seat temperature may
be reduced or the warm water heater and toilet seat
heater may be turned off.
Please check
fi
rst
Is the Power LED
illuminated?
Is the Energy saver
LED illuminated?
First, try the actions described on pages 37 - 40.
If the problem persists, consult the installer, seller, or
TOTO customer service.
(see contact information on the back cover.)
If a water leak occurs, close
the shutoff valve.
■
Is the breaker on the distribution board turned on?
→
Check whether there is a power outage or the breaker has turned
"OFF".
■
Is the "Power ON/OFF" setting "OFF"?
→
Switch it to "ON" with the control panel. (Page 14 Step
1
-
2
)
■
Is the "Power" LED on the main display
fl
ashing?
*1
→
The main unit is not mounted properly. Mount them correctly
again. (Page 30)
<Power>
Soft cloth soaked in water
(to prevent scratching)
Paper cup
*1 Except SW3004
Loosen the water drain plug until water
comes out from around the wand.
• Water comes out from around the wand.
(It takes about 3 minutes to complete draining.)
* The water drain plug cannot be removed.
5
2
Press
to extend the wand,
and then press
again to
return the wand.
(Release the pressure from the water supply pipe.)
36
37
Reference
