Toto Washlet C110 SW523 Instruction Manual Download Page 3

4

5

WARNING

Use only a mild dish detergent diluted with water to clean your Washlet. Do
not use the following to clean the Washlet.

Toilet bowl cleaner, household cleaner, benzene, paint thinner, powdered cleanser,
or nylon scrubbing pads.

Use of any cleaning product other than diluted dish detergent may crack the
plastic and cause injury to the user or may damage the hose resulting in water
leakage.

Do not stand on or place heavy objects on top of the toilet.

To avoid injury or damage to the toilet unit, do not stand on or place heavy
objects on top of the toilet.

Do not raise the toilet seat or lid while objects are resting on top of the toilet.

Lifting the toilet seat/cover with objects resting on them could cause the main unit
to become detached, resulting in injury.

Do not bend or crush the water hose.

Bending or crushing the water hose may result in water leakage.

When not using the Washlet over an extended period of time, drain the water
out of the hose and pull the electrical plug from the wall outlet.

Water left standing in the toilet hose over an extended period of time could cause
irritation to the skin.

Refer to Page 25 for instructions on draining the hose.

If water leakage should occur,
always close the water shutoff valve
and then turn off the water.

When installing the water drain valve with water filter, make sure that it is
securely tightened in its proper position.

Improper tightening of the water valve may result in water leakage.

Preventing damage due to frozen pipes and hoses.

Frozen water pipes will cause the Washlet main unit and the pipes to break,
resulting in water leakage.

Regulate the room temperature to prevent the pipes and hoses from freezing
during cold months.

Refer to Page 24 for instructions on how to prevent frozen pipes.

To prevent sudden water leakage, do not remove the water filter with drain
valve when the water shutoff valve is open.

Refer to Page 22 for instructions on cleaning the water filter.

Do not install base plate to Washlet when not attached to the toilet.

Fire or damage may result.

Turn clockwise

Turn 
clockwise

Do not use this product while smoking.

To avoid the risk of  fire, do not smoke while using this product.

To reduce the risk of electrocution:

1.

Do not use while bathing.

2.

Do not place or store the product where it can fall or be pulled into the tub or sink.

3.

Do not place in or drop into water or other liquid.

4.

Do not reach for the product when it has fallen into water. Unplug immediately.

DANGER

To reduce the risk of burns, electrocution, fire
or injury to persons:

1.

Close supervision is necessary when this product is used by, on, or near children or
invalids.

2.

Use this product only for its intended use as described in this manual. Do not use
attachments not recommended by the manufacturer.

3.

Never operate this product if it has a damaged cord or plug, is not working properly, has
been dropped or damaged, or has been dropped in water. Return the product to a service
center for examination and repair.

4.

Keep cord away from heated surfaces.

5.

Never block the air openings of the product or place it on a soft surface, such as a bed or
couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and
other similar items. 

6.

Never use while sleepy or drowsy. 

7.

Never drop or insert any object into any opening or hose.

8.

Do not use outdoors. Do not operate where aerosol (spray) products are being used or
where oxygen is being administered.

9.

Connect this product to a properly grounded outlet only. See Grounding Instructions.

10. Reservoir should be filled with water only.

WARNING

Save these instructions.

Introduction

 D08248-2  09.1.9 2:03 PM  ページ 4

Summary of Contents for Washlet C110 SW523

















Reviews: