Toto TBW01003B1, Manual

Page: 10 / 11

8 7
Faucet installation
Tools to be prepared before installation
Sealing tape Screw driver Hexagon wrench Wrench
Confirmation before installation
■Make sure that the water supply pipe has been shut off and
the waterway has been cleaned.
■Read the instructions for construction carefully and install
according to the main points of it.
■Check the components in your packing box are the same as
shown below.
Shower head
Connection tube
O-ring
Decoration cap
Elbow
Faucet installation
1. Faucet installation (TBW01003B1 as an example)
Firstly clean the water supply pipe and make a pressure inspection. Take care not
to mix silt or other impurities into the shower or the water supply pipe during
installation.
2. Installation of base:
(1) Install the O-ring on the decorating cover and then put it on the connecting
pipe;
(2) Screw the elbow into the water supply pipe connection and wind an appropriate
amount of sealing tape on the connecting pipe threads and screw it in the elbow
(the chamfered end connects with the connecting pipe). Adjust the elbow and
connecting pipe for the connecting pipe to direct vertically down.
(3) Connect the shower head with the connection tube. Take care not to drop out
the filter screw and the gasket. Adjust the direction of “TOTO” with reference to
the completion drawing. Use the hexagon wrench to fit and tighten the small screw
into the screw thread hole.
(4) Finally, just adjust the decorating cover properly.
Shower head
Connection tube
Sealing tape to be
winded here
O-ring
Water saver, filter neet and
gasket available inside
Decoration cap
Elbow (
※
Note that the chamfered end
connects with the connecting pipe.
Do not install reversely.)
Small screw
※
It is imperative to use such
expansion bolt and pipe securing
clamp as having a sufficient
strength to secure this elbow