Note
40
Washer
Nut
Through hole
(
φ
13)
Bolt
Decorative
plywood sheet
Paper honeycomb
Mounting plate
Flange
Cover
Finished wall surface
Within 120
Resin pipe
14
*For installation methods not shown in this manual, please contact TOTO’s branch office, branch shop, or sales office.
Note
Use the outer holes
①
Carry out centering and then make
φ
13-mm
through holes for pipes.
②
Insert the resin pipes into the through holes.
Resin pipes are used to prevent wall buckling
which occurs when the handrail is installed
on a paper honeycomb wall or the like.
Therefore, be sure to check the wall before
installing the handrail.
③
Screw the continuous-thread studs in the
outer bolt holes of the mounting plate to the
end, and while inserting them into the resin
pipes from the back of the booth, put the
mounting plate on the wall.
*The mounting plate has 4 outer bolt holes
and 4 inner outer bolt holes. Check the bolt
holes before installation.
④
Put the bolts through the mounting holes of
the flange, and then tighten with the washers
and nuts.
⑤
Press the cover against the finished surface.
Note 1
Note 1
Prepared hole guide for fixing bracket T110D22R
*Do not use the inner holes because they are the mounting hole
positions for the handrail (T114 type).
Mounting hole positions (outer holes) of the handrail
(T112 type/T113 type)
φ
65
Mounting plate
46
46
(Unit: mm)
Toilet booth: Fixing by clamping
7
-7
. Installing the Handrail
Fixing bracket part number
T110D22R
When the toilet booth is made from paper honeycomb, melanin/polyether
decorative plywood, or the equivalent, which is 40 mm in thickness, only
versatile I type handrail, versatile L type handrail, and L type handrail for sitting
toilet (front protrusion dimension: 120 mm) can be installed.
Note 1: When you use reinforcing wooden blocks for the toilet booth or when
the toilet booth has strong walls without hollow, do not use resin pipes
that come with the product, but make
φ
8-mm through holes for bolts,
to mount the handrail.
