Screw the hexagon nut tightly, and fix the faucet
part on the earthenware.
* To screw the hexagon nut, please use the
following tools.
x
Socket wrench (size 13mm)
x
T-wrench (size 13mm)
x
Adjustable wrench (size 13mm)
Connect the joint for the check valve with the water supply pipe
Connect the water supply pipe with the joint for
the check valve.
y
Please avoid the washer from falling
down.
Angle valve for
water supply
Joint for check valve
Washer
Water supply
pipe
Caution
Remove the cover of the functional part
Remove the cover of the functional part in the
direction shown in the figure.
Cover of functional part
(Dry cell type)
Cover of functional part
(Alternating current type)
Drill 2 holes in the wall as shown
in the figure.
Install the functional part onto the
wall as shown in the figure.
Unit: mm
Insert the connecting line of the sensor
Insert the connector as shown in the figure until it clicks.
(Dry cell type)
(Alternating current type)
Connector for sensor
Connector for sensor
Insert the power plug (AC type)
Insert the power plug into the power socket.
When the power supply is connected, the
sensing distance is set automatically and
immediately, please do not cover the sensor with
your hands or put any object in the earthenware.
(it takes about 20 seconds)
Make sure the indicator light of the sensor is illuminated
When the sensor is not covered by hands and there is no
object in the earthenware, please make sure the indicator
light of the sensor of the faucet does not flash.
* If the indicator light of the sensor still flashes,
please adjust the direction of the faucet slightly until
the indicator light does not flash.
* The indicator light automatically stops flashing about
10 minutes after the power supply is connected. If
you have not finished adjustment to the faucet before
the indicator light automatically stops flashing, please
unplug the connector for the sensor, and insert it
again.
y
When checking the indicator light of the sensor,
please orient the sensor towards the spherical
center of the earthenware.
y
Depending on types of earthenware, the
indicator light of the sensor will not stop flashing
sometimes. In this case, please set the product
normally. (the indicator light will stop flashing
about 10 minutes later)
Sensor
Power plug
Caution
Caution
Fix the faucet
Hexagon nut
Install the cover of the functional part
After you make sure the connector is
connected, please close the cover of the
functional part and fix it with screws.
(Dry cell type)
Cover of functional part
Cover of functional part
(Alternating current type)
y
Please close cover of functional part tightly.
y
Please make sure the functional part is installed
in correct direction.
y
When you close the cover of the functional part,
please check whether the connecting line is
caught.
Caution
9
11
12
10
Install the functional part