0GU5034, 09/2013
Safety Instructions
Always follow the safety precautions/warnings when using and installing the Acrylic Bathtub.
Acrylic Bathtub Installation Instructions
Failure to follow any of these Installation Instructions will void the warranty.
WARNING
:
Improper use or installation of this product may result in death or serious injury.
CAUTION:
Improper use or installation of this product may result in injury or property damage.
This symbol indicates a prohibited use of the product.
This symbol is used to indicate a required step in the use of this product.
!
!
!
WARNING:
!
CAUTION:
!
Please carry out the installation as described in
this manual. Improper installation could result in
damage, leaks, fire or electrical shocks.
!
Be sure that any electrical installation is per-
formed by a licensed electrician in accordance
with all laws and regulations.
!
Do not climb into the bathtub to perform any tasks
other than intended use. Injury or bathtub dam-
age could result.
Connect to a proper water source to avoid the
risk of skin irritation.
!
The electrical circuit supplied for the AirBath must include a suitable ground fault circuit interrupter (GFCI)
as required by NEC article 680.70. The unit must be connected only to a supply circuit that is protected by
a ground fault circuit interrupter (GFCI). Such GFCI should be provided by the installer and should be tested on a
routine basis. To test the GFCI push the reset button. Power should be restored. If the GFCI fails to operate in
this manner, the GFCI is defective. If the GFCI interrupts power without the test button being pushed there is a
ground current flowing, indicating the possibility of electric shock. Do not use the AirBath. Disconnect the AirBath
and have the problem corrected by a qualified service representative before using.
After opening, properly dispose of any unneeded
packaging materials. Box or plastic materials my
pose a suffocation hazard.
!
When transporting the bathtub, do not hold by
the air hose, pump, control box or other external
parts or bump them against hard objects. Leaks may
result.
!
When installing, leave a 1/8” (3 mm) gap be-
tween the tub and any rigid wall or tile. Also,
carefully caulk all the edges to prevent leaks or damage
from thermal expansion.
!
Do not install the hot and cold water lines in
backwards. Scalding could result.
!
Do not bump the bathtub against, drop or store
any rigid objects into the tub. The tub may be-
come cracked, damaged and/or leak.
Avoid mortar, plaster, or other adhesives from
contact with the bathtub surface. Damage to the
bathtub surface may result.
Check local laws and codes for any specific in-
structions on installation and/or use not covered
in this manual.
!
!
