Attentions in use and maintenance
Maintenance
To maintain a beautiful appearance of the product, the user is requested to
conduct maintenance and care in the following method.
1. Wipe with a piece of soft cloth frequently and use a piece of soft cloth
dipped in water to wipe from time to time.
2. When dirt exists obviously, please use water to wash sufficiently after
wiping with a neutral detergent.
Service condition and attentions in use
Serrice condition
1. Cold water supply*hot water supply pressure
Minimum pressure ………………… 0.05MPa (flow pressure)
Maximum pressure ………………… 1.0MPa (static pressure)
2. When the sprinkler is used as ancillary component,it is advised that the water
pressure should be more than 0.2Mpa,otherwise,the performance of the sprinkler
can not be played fully.
3. The temperature for water supply is 4~90
℃
. It is suggested to use the water
temperature of 60±5
℃
. Do not use steam to supply hot water.
4. The ambient temperature for use is above 0
℃
. If not, the water nozzle may deform
and crack due to freezing.
5. To prevent internal sprinkler damage,the water outlet temperature on the sprinkler
side shall not exceed 60
℃
.It is suggested to use a temperature below 45
℃
.
6. Being out of use for a long time may result in internal and external rust to the
water nozzle and being unable to be used.
7. If you want to scrap this product, do not treat it as you do for general domestic
grabage. Please follow relevant statutes to have it treated, recovered and collected
appropriately by an independent recovery system.
8. The product in these instructions has a cleaning function.
Attentions in use
Warning:it means that ignoring this mark and misoperation may cause serious
personal injury and death.
Attention: it means that ignoring this mark and misoperation may cause
personal injury or property loss.
Warning
1.Children are not allowed to use or can use only under the custody of adult. Such
special groups as the aged and disabled should be accompanied by those with
behavioral competence when using it.
2.The hot water supply side of the water nozzle is in a condition of high
temperature. Do not allow skin to contact with the hardware surface directly.
Otherwise,scalding may occur.
3.Do not reverse cold*hot water pipes. Otherwise, scalding may occur.
4.Do not use steam to supply hot water. Otherwise, scalding may occur.
5.In construction, do not install and use the G1/2 or G3/4 internal threads of this
product with R1/2 or R3/4 connector. Otherwise, the main body threads may
crack, resulting in such quality problems as water leakage, etc.
4
5
Attentions
1. As the ceramic cartridge is a precise component, do not dismantle it without
authorization. Otherwise, such poor conditions as water leakage, etc. may be
caused.
2. In supporting use,it is suggested that the water pressure should be above
0.2Mpa.Otherwise,the performance of the water nozzle may not be sufficiently
taken advantage of.
3. Do not impact the product. Otherwise, failure, water leakage may occur.
4. It is imperative to use a neutral detergent in cleaning. Other detergents
than a neutral one may damage the plating coat or make the surface discolor.
5. Do not use any such detergent as acidic detergent and abstergent, polishing
powder, etc. Containing thick particles and nylon brush. Otherwise, the
plating coat may be damaged, etc.
6. It is allowed to use a piece of soft cloth to wipe or use from time to time a piece
of cloth immersed in machine oil or vehicle wax to wipe. However, do not
contact with resin components. Otherwise, they may lose the gloss
and become rusty.
7. With the product design being updated constantly, the physical object may
not coincide with the figure. However, the basic principle for installation, use
is the same.
