Toto Link ND300V2, Manual

Page: 7 / 57

7
3. HARDWARE INSTALLATION
3.1 Hardware Installation
For the first time you use this ADSL Router, wired connection is recommended to setup the
router. Please follow below steps to build correct connections through provided UTP cables.
Step1: Connect
Modem Router’s ADSL port to external Filter’s (provided by your ISP)
ADSL port.
Step 2:
Connect your PC’s network interface to any one LAN port of Modem Router.
Step 3: Plug the Power adapter into the router and then into an outlet.
Step 4: Power on the Router and turn on your PC.
3.2 Check the Installation
The control LEDs of the Modem Router are clearly visible and the status of the network link
can be seen instantly:
1. With the power source on, once the device is connected to the external filter, the Power,
CPU, ADSL and LAN ports LEDs of the Modem Router will light up indicating a normal
status.
2. After a few seconds, the LAN LED indicators without connection go out and WLAN
indicator will light up.
3.3 Set up PC
The default IP address of the Router is 192.168.0.1, the default Subnet Mask is
255.255.255.0. Both of these parameters can be changed as you want. In this guide, we
will use the default values for description.
Connect the local PC to the LAN port on the Router. There are then two ways to configure
the IP address for your PC.

Configure the IP address manually
1. Set up the TCP/IP Protocol for your PC.
2.
Configure the network parameters. The IP address is 192.168.0.xxx (“xxx” range from 2
to 254). The Subnet Mask is 255.255.255.0 and Gateway is 192.168.0.1 (Router’s
default IP address).

Obtain an IP address automatically
1. Set up the TCP/IP Protocol in Obtain an IP address automatically mode on your PC.
2. Power off the Router and PC. Then turn on the Router and restart the PC. The built-in
DHCP server will assign IP address for the PC.
Now, you can run the Ping command in the command prompt to verify the network