It is a good idea to
start every step in-
serting nuts into
beams (if the step
requires).
Use the back of the
screwdriver to push
in the nuts.
After entering the
first slot, nuts tend
to tilt. Use your
thumb to push it
back straight, and
then again use the
screwdriver to in-
sert the nut all the
way in.
Use the Totem
Wrench Socket
(Blue) to insert Ny
-
lon Standoffs used
to assemble the
electronics boards.
Some of the nuts
are missing threads.
This is a manufac-
turing issue and we
are working on it. In
the mean time, we
add few extra nuts.
We apologize for
the inconvenience.
Use Beam/Bolt
ruler to determine
the length of beams
and bolts.
For more tips, please visit the link below:
https://totemmaker.net/blog/totem-mechanics-for-beginners/
STARTING TIPS
Inserting nuts (1)
Inserting nuts (2)
Faulty threads
Tightening
standoffs
Ruler
Summary of Contents for HOCKEY BOT
