•
Tilt table to desired position by turning screw to adjust table tilt.
•
Lock the table in position by tightening the lock handle.
Miter gauge (Fig.13)
Use an angle fence to secure and hold the workpiece at the desired angle to prevent
angled cuts. Use the scale to adjust the gauge to the desired angle.
Caveat
Never use the angle fence and the rip fence at the same time. The blade could get stuck
in the work piece. The operator could be injured and/or the workpiece could be damaged.
push lever
When cutting smaller workpieces, you can do so by using the push lever for your safety.
Cleaning brush
Make sure the brush is in contact with the blade to properly remove foreign particles from
the drive wheel.
Maintenance
Make sure the machine is disconnected from the power source before attempting to
repair or remove any component.
Maintenance
•
If the power cord is worn or cut in any way, replace it.
•
Replace any damaged or missing parts.
•
Use the exploded view to order parts.
Cleaning
•
Keep the machine and workshop clean. Do not allow sawdust to accumulate on
the band saw.
•
Keep the wheels clean. Debris on wheels will cause poor performance and saw
blade slippage.
•
Keep the mechanisms and threaded or sliding surfaces clean and free of foreign
particles.
•
Use the band saw with a dust collector to optimize cleaning.
Lubrication
•
Shielded ball bearings are permanently lubricated and do not require additional
lubrication.
angle
guide
Summary of Contents for TS730301
Page 1: ...BAND SAW...
Page 18: ...BAND SAW...