6
Set up
Mounting
Attaching the saw blade
To change the saw blade, set the pendulum action switch to step "0".
To open the saw holder:
•
Turn the ring counterclockwise (jig saw upside down) and hold it in position.
•
Fully insert the saw blade into the slot in the saw holder with the teeth forward
and release the ring, which will automatically rotate and hold onto the top of the
saw blade.
•
Push the saw or saw blade into the bracket again to make sure it is locked in
position.
•
To remove the saw blade:
o
Hold the saw blade
o
Turn the ring counterclockwise
o
Raise the saw blade
Note: Remove the transparent saw blade guard to facilitate mounting or removal of the saw
blades.
Attention
The teeth of the saw or saw blade are very sharp. It ejects automatically and quickly, so
avoid targeting people.
Using the parallel guide
The parallel guide allows you to make precise parallel cuts using the metric scale.
•
Place the parallel guide in the required position.
•
Slide the parallel guide in from the appropriate side (left or right) as appropriate.
•
Make sure the guide surface of the parallel guide points downward.
