Total TP880-1, Manual

Page: 20 / 34

for oil quantity and type
．
● if the warning light stays on continuously
，
the engine will start and continue to run but
the low oil shutoff switch is not functioning properly
．
Check the switch for proper wire
connections. If the light continues to stay on
，
replace the switch
．
● if the warning light does not flash quickly once
，
and the engine starts and continues to
run
，
the low oil shutoff switch is not functioning properly
．
Check the switch for proper
wire connections and grounding
．
If the light still does not flash when starting the
machine
，
replace the switch
．
5.7 Proper Operation
See Graphic 3
Keep vibratory rammer clean and dry
．
Avoid no-load strokes
．
Never allow the rammer
to run full throttle when forcing away materiaI or when lifting the equipment
．
For optimal control, performance
，
and minimaI hand/arm vibration, grasp handle as
shown
．
Hand/arm vibration (HAV) has been optimized for this positioning
．
Reported
HAV levels are measured at position A just in front of the hand position shown in
conformance with EN 1033 and ISO 5349.
CAUTION
： To prevent damage to the rammer
，
do not allow the rammer to run on its side
．
If the rammer should tip on its side
，
place the rammer in the position shown
，
then shut
off the engine by turning engine switch to "OFF"
．
Graphic 3
5.8 Proper Compaction
See Graphic 4
5.8.1 Run rammer at the full throttle position(a2)for maximum performance
．
5.8.2 Guide rammer with its handle
．
Allow machine to pull itself forward
．
DO NOT try
to over-power the machine
．
5.8.3 For best compaction
，
the shoe must hit the ground flat (b)
，
not on its toe or heel.
This will save on excessive shoe wear
．
19