Total TGT11356, Manual, Page: 8 / 14

8
Machine operation
Dry running for more than 2 minutes causes damage to the high pressure pump.
If the machine does not build pressure within 2 minutes, turn it off and proceed
according to the instructions in Chapter "Troubleshooting".
High pressure operation
• Keep a distance of at least 30 cm when using the jet to clean painted surfaces
to avoid damage.
• Make sure the on/off switch is in the OFF position and insert the plug into a
properly installed outlet.
• The pressure washer must be used on a safe and stable surface in an upright
position.
Connect the product to the electrical and water supply as described:
•
Turn on the water supply.
• Hold the spray gun with both hands.
•
Direct the nozzle of the chosen accessory away from you towards the surface
to be cleaned.
•
Unlock the trigger and press until a constant amount of water flows through the
nozzle, allowing any air trapped in the hose to escape.
•
Release the trigger.
•
Turn on the "ON/OFF" switch
•
Hold the spray gun with both hands. Direct the water jet towards the object to
be cleaned and press the trigger.
•
Release the spray gun lever; the device will turn off again and stop the water
jet. High pressure remains in the system.
Note: Beware of kickback when pulling the trigger.