Total TG1101256E, Operating Instructions Manual

Page: 9 / 13

9
When the outer flange washer is tight, release the spindle lock button and remove the
key.
switch
The on / off switch is in the “OFF” position. The angle sander is started by pushing the
on / off switch forward. To stop the tool, release the on / off switch and it will return to the
“OFF” position.
Attention
The disc will continue to rotate for a few seconds after the angle sander has been turned
off.
Always wait until the blade has come to a complete stop before placing the angle grinder
on a surface. Do not try to operate the spindle lock button while the disc continues to
rotate.
To use the sander
Attention
Do not turn on the sander while the disc is in contact with the workpiece. Allow the disc
to reach full speed before starting. Hold your angle grinder with one hand on the main
handle and with the other hand firmly around the auxiliary handle.
Always position the protector so that as much of the exposed disc as possible is pointing
away from you. Be prepared for a series of sparks when the record hits the metal.
Inner
flange
Spindl
Disk
Outer
flange
On / off button