TACKS PROVIDED
6b
ATTACH THE ROOF FELT
Use the felt lengths
provided.
20a.
Apply the roof felt as shown.
Apply lower levels first to create correct rain run off
positions.
20b.
Using a hammer, tack down the felt with the tacks provided in a
neat fashion.
20c.
Trim down excess felt with a stanley knife.
Remember to overlay the 1st felt to avoid rain leaks.
20d.
Tuck and fold edges neatly and tack in place
to hide any loose edges. Check that all areas are
covered and there are no holes to avoid any rain
water getting through your felt roof.
STEP • 20
STEP • 21
14
= Drill Points using
screws provided as shown
x2
4.0 x 70mm
Per Floor Section
x3
x28
4.0 x 38mm
FELT STRIPS
ROOF FELT
3rd
ATTACH FELT STRIPS
Create the Final Roof
Edges.
Final steps finishing off
the roof.
21a.
Using the felt strips provided cover the edges
of the roofs and ends of the roof felt. You will need to measure
these and saw to fit to your requirements and create the perfect roof finish as shown below.
21b.
Drill in the felt strips as shown on front and back of the shed to finish the roof off. Use the
framework of the roof blocks to screw the felt strips down to. The felt strips will give your shed a
neat finish for the roof and hide any overhang areas of the roof felt.
NOTE:
Location of the Felt Strips
21c.
Felt Strips must be same height as roofing
felt to allow rain water to run off. See Diagram on
the right.