total sheds Pent Potting Shed, Assembly Manual

Page: 8 / 12

STEP • 10 STEP •11
07
© Sheds (Midlands) Limited 2021
www.totalsheds.co.uk
= Drill Points using
screws provided as shown
x2
4.0 x 70mm
Per Floor Section
x3 x3
4.0 x 70mm
Per Window Panel
4ft DOOR PANEL
DOOR PANEL
Attach Door Panel Next
to the 2ft
Window Panel
10a.
Use the RED areas below as reference to the joining points of the final panel. Note the 4ft section should
fit perfectly to continue the front section.
x2
4.0 x 70mm
Per Floor Section
= Drill Points using
screws provided as shown
x3 x4
4.0 x 70mm
6ft SIDE PENT ANGLE TOPS
SIDE PENT ANGLE TOPS
Now attach all the 6ft
Side Tops of Pent Shed
End Panels. (Over the top
of both side panels).
DID YOU KNOW?
Door panels can be placed anywhere a 4ft panel
is. The 4ft Door must be placed opposite the 4ft
back panel and on top of a 4ft floor.
10b.
This is the last remaining panel. So, this
panel will need screwing down on both sides
(As Shown). Once competed, check that the
shed is square and screw to the base.
10b.
This is the last remaining panel. So, this panel will need screwing down on both
sides (As Shown). Once competed, check that the shed is square and screw to the base.