5
STEP 4.
Move to the back of the
PlyoRebounder facing the handle column.
With the PlyoRebounder ring in the
lowest level, position the clamp around
the handle column and the ring cylinder
as shown below.
bolt
handle column
ring cylinder
red lever
Turn the red lever to the right in the
released position (see the sticker on
clamp). Then thread the bolt through the
left clamp hole and through the cylinder on
the ring to the right side of the clamp but
not yet through the right clamp hole.
STEP 5.
With your left hand, press the bolt
through the right side clamp hole while
pushing forward on the red lever with your
right hand to align the bolt to the hole.
Install the washer and then the nut.
washernut
Now tighten the nut and bolt with the two
supplied wrenches until they begin to get
tight. Then loosen the nut half a turn.
Now you can use the PlyoRebounder.
INCLINE ADjUSTMENT
A.
Rotate the red lever to point toward the
right.
B.
Grasp the inner ring; pull and hold out
the knob.
C.
Slide the clamp to the desired incline
level and release the pin into the hole. If
it does not pop all the way into the hole,
move the clamp up or down until it does.
D.
Rotate the red lever all the way to the
left and push and pull the ring to ensure it
is secure.
NOTE:
If the clamp rattles or moves when
used, make sure the pin is engaged all the
way and the lever is pointing to the left as
you see it from the back.
ASSEMBL
Y
OWNER’S GUIDE |
TOTAL GYM PLYOREBOUNDER
®
OWNER’S GUIDE |
TOTAL GYM PLYOREBOUNDER
®
