9
ELEVATE
®
JUMP
TM
OWNER’S GUIDE
ELEVATE
®
JUMP
TM
OWNER’S GUIDE
ASSEMBLY & INSTALL
STEP 6.
Using the hardware (D, C) as
indicated; attach the Rear Base to the
Rear Struts as shown below. Ensure both
the logo and the warning stickers are
right side up. Install screws 1 and 2 first,
then proceed to install the rest; tighten
completely.
Screw 1
Screw 2
D,C
D,C
See
close-up below
STEP 7.
Lay the ELEVATE Jump on
its side. Using the hardware (C, E) as
indicated; attach the Rear Struts / Incline
Strut as shown. Tighten completely.
NOTE:
Installing the screws in the order
shown may be easiest.
C
Close-up
E
1
6
3
7
5
2
8
4
See close-up below
STEP 8.
Turn the ELEVATE Jump upright
and, using the hardware (H, J, K, S) as
indicated; attach the Squat Stand to the
Struts. Tighten completely. Installing the
screws in the order shown may be easiest.
Once screws are fully tightened, push on
all 12 caps (S).
Plugs installed
at the factory
S,H,K
K,J,S
1
5
4
3
6
2
STEP 9. IMPORTANT: RETURN TO
STEPS 2-4 AND TIGHTEN ALL SCREWS
COMPLETELY.
STEP 10.
The screws A in step 2 and 3
may become loose after use in one day
due to stretching and seating of other
parts. Retighten those screws and nuts P
if they become loose. One retightening is
usually enough.
