8
ELEVATE
®
JUMP
TM
OWNER’S GUIDE
ASSEMBLY & INSTALL
STEP 2.
Insert the Left Squat Strut on to
the Left Rail by positioning the bottom of
the Left Squat Strut in-between the Left
Rail and Bungee Panel (as shown in close-
up below). Gently wiggle the Strut all
the way on to the Rail until the holes are
aligned. Install the hardware (A, B, C, P) as
shown. Do not tighten completely.
See
close-up
below
STEP 3.
Repeat STEP 2 on other side,
attaching the Right Squat Strut to the
Right Rail using the hardware (A, B, C, P)
as shown, but do not tighten completely.
See
close-up
below
Close-up
A
C
P
B
C
STEP 4.
Install the hardware (G, F) on
both rails as shown below.
G
F
F
G
STEP 5.
Using hardware (R), as indicated,
first insert plastic plugs into hole 1 on the
inside and outside of each Strut (as
shown below).
Hole 1
These holes
come already
plugged - do
not remove
Hole 1
Next, attach Front Base to holes 2, 3 and
4 as shown below using hardware (H,K,J)
as indicated. Make sure to install the
washer (K) on the bolt first (H). After all
the bolts and nuts are installed, tighten
them completely. Then cover each with a
plastic cap (M).
J
H,K
Hole 1 plugged
in Fitness Setting
Hole 2
Hole 3
Hole 4
The image below is how the Front Base
attached to the Struts should look for the
FITNESS Setting.
Front Base does
not attach to
Hole 1 in
FITNESS Setting
A
C
P
B
C
Insure the Strut is
above the Bungee Panel
highlighted in blue.
Close-up
