Total Audio Control COMPRESSOR ONE 500 Series, Assembly And User'S Manual

Page: 54 / 68

54
On the other hand for MASTER/SLAVE operation COMPRESSOR ONE requires two signal LINK bus system (LINK_MS and
LINK_RMS). This is accomplished by external wiring through the LINK Molex connectors J9 and J10 as shown below.
However, the MASTER bus must always be wired in the same manner by using J9: B and J10: B pins.
Do not twist these wires, they may be loosely tied. They do not need screening but should be kept as short as possible while
allowing module removal.
PLEASE NOTE: When using any rack not manufactured by Total Audio Control DO NOT FIT P1 JUMPER as this might result in
LINK_RMS and LINK MASTER Busses being shorted together which could cause damage.