Toss RESISTRON ROPEX RES-409, Operating Instructions Manual

Page: 34 / 56

Controller functions
Page 34 RES-409
Address
(hex)
Value
(dec)
Meaning
0000
0001
0002
0003 0…T
max
0…T
max
0…T
max
0…T
max
Current set point 0 (in °C)
Current set point 1 (in °C)
Current set point 2 (in °C)
Current set point 3(in °C)
0004 -20…T
max
Current actual value (in °C)
0005 (  10.4.1) Full current controller status
0006 3 digits (BCD
coded) Digits 1…3 of 6-digit controller number
0007 3 digits (BCD
coded) Digits 4…6 of 6-digit controller number
0008 0…40 Current calibration temperature (in °C)
0009 (  10.4.2) Acknowledgment message (current actual value with reduced controller status)
000A As of
Feb. 2007:
3…99
Up to
Jan. 2007:
3…20 Current upper temperature tolerance band limit
000B 0…5 (  10.3) Current heatsealing band alloy/temperature range
The following CAN messages are only available on controllers manufactured as of February 2007:
000C 0…65535 Current fault and AUTOCAL status
(
 section 10.4.3 "Fault / AUTOCAL status (as of February 2007)" on page 37)
000D 0…2 Hold mode: 0=OFF, 1=ON, 2=2 seconds
000E 0, 1 AUTOCOMP status: 0=OFF, 1=ON
000F 0…500 Maximum set point
0010 0…999 Software revision
0011 0…99 Software version (default value: 00)
0012 400…4000 Current variable temperature coefficient (TCR in ppm/K)
0013 0…2 "Temperature OK" bit: 0=OFF, 1=active if set = act, 2=active if set = act with latch
function
0014 3…99 Lower temperature tolerance band limit
0015 3…99 Upper temperature tolerance band limit
0016 0, 1 Temperature diagnosis: 0=OFF, 1=ON
0017 0…99 Temperature diagnosis delay in 0.1s
0018 0…999 Heatup timeout in 0.1s
0019 17…30 Measuring impulse length in 0.1ms
001A 0…3 Temperature range: 0=200°C, 1=300°C, 2=400°C, 3=500°C