Insert by sliding along the Track
groove, Nip the groove of the
Track with the Fastener.
②
Be sure to use four fixing screws or more for each bracket. Using too few screws
may cause the Product to fall off at some point.
For the Rail Set with OT Splice, make sure the Joint part is adequately supported
during the mounting process. The Product may fall off .
For the Rail Set with OT Splice,
this task should be performed by no fewer than two people.
ATTENTION
Tighten the screw to ensure firm
attachment.
③
Installation method of the Motor
Loosen the Motor mounting screws,
then insert the Motor into the Motor
side Pulley while keeping the Motor
mounting screws in place.
①
ATTENTION
Check to confirm that the Brackets are securely attached to the Track.
Insert cardboard pads in the Rail groove
at 1m intervals.
(Use the cardboard pads used for
packaging.)
Installation method of the product body
①
Tighten the Motor mounting screw,
and fix the Motor surely.
②
Within 1m in equality
ATTENTION
①
Check to confirm that the Motor is securely attached to the Track. (Pull down on
the Motor to confirm that it is securely mounted.)
Disassembly method of the Motor
While supporting the Track, remove
the mounting screws for the Bracket
and remove the Rail set.
Disassembly method of the Rail Set
Loosen the Motor mounting screws, and
ｒ
emove the Motor while pulling to keep the
mounting screws clear.
①
cardboard pads
ATTENTION
To keep the Belt from coming off, lift the Track only after inserting the
cardboard pads.
Lift the Track and mount the product with
the mounting screws.
②
