19
Connecting the Wallplate Keypad Controllers
1.
Set the three DIP switches on each Keypad Controller to one of the four
identification patterns listed below. Each Keypad Controller connected to the same
Master Controller/Amplifier must have a unique identification. Note that the
identification is localized to each Master Controller/Amplifier device. If multiple
Master Controllers are in use, each one will have its own set of keypads with the
same identification numbers as keypads on another Master Controller.
2.
Connect one end of an Ethernet cable to the RJ45 port on the front of the Keypad
In-Wall Hub Connection Plate. Connect the other end to the Keypads port on the
back of the Master Controller/Amplifier.
3.
Repeat step 2 for each other Master Controller/Keypad In-Wall Hub Connection
Plate set in the system.
4.
Connect one end of an Ethernet cable to the RJ45 port on the back of one of the
Keypad Controllers. Connect the other end to one of the RJ45 ports on the back of
the Keypad In-Wall Hub Connection Plate. It does not matter which port is
connected because the DIP switches are used to identify each Keypad Controller.
5.
Repeat step 4 for each other Keypad Controller in the system.
Summary of Contents for 14524
Page 1: ...1 ...
