18
INSTALLATION
Note: Before making any connections, ensure that all equipment is powered off and
unplugged to prevent the possibility of personal injury or equipment damage due to
electrical shock.
Test Installation
Before drilling any holes and before running any cables through walls, it is highly
recommended to perform a test installation first. The test installation should consist of a
complete connection of all speakers, wallplates, source devices, etc., so that full
functionality can be verified prior to making permanent or difficult installation actions.
Ideally, you should route cables from the master location to the intended location of each
zone, connect speakers and wallplate keypads in each zone, and perform full functionality
testing using the keypads, the system's remote control, and any remote controls for
connected source devices.
Connecting Multiple Multizone Controllers
If you will be using multiple multizone controllers, you will need to connect them together
using the ribbon cable supplied with each unit.
1.
Decide which device will be the Master device. Slide the Master/Slave switch on
this unit to the Master position.
2.
Plug one end of the included ribbon cable into the Expansion Output port on the
back of the Master device. Plug the other end into the Expansion Input port on the
back of the first slave device.
3.
Slide the Master/Slave switch on the first slave device to the Slave 1 position.
4.
If connecting a third controller, plug one end of the included ribbon cable into the
Expansion Output port on the back of the first slave device. Plug the other end into
the Expansion Input port on the back of the second slave device.
5.
Slide the Master/Slave switch on the second slave device to the Slave 2 position.
Summary of Contents for 14524
Page 1: ...1 ...
