– 4 –
EN
4
Part names and functions
Remote controller (WH-L11SE)
•
Max. 8 indoor units can be operated by a remote controller as a group.
•
Illustration of LCD shown below is for explanation. It may differ from the actual LCD.
1
Infrared signal emitter
Transmits a signal to the indoor unit.
2
START/STOP button
Push the button to start operation.
(A receiving beep is heard.)
Push the button again to stop operation.
(A receiving beep is heard.)
If no receiving sound is heard from the indoor unit,
push the button twice.
3
Mode select button (MODE)
Push this button to select a mode.
Each time you push the button, a mode is selected
in a sequence that goes from A : Auto changeover
control,
: Cool,
: Dry,
: Heat,
: Fan only,
and back to A. (A receiving beep is heard.)
4
Temperature button (
)
5
Fan speed button (FAN)
Push this button to select fan speed. When you
select AUTO, the fan speed is automatically
adjusted according to the room temperature.
You can also manually select the desired fan speed.
(LOW
, LOW
+
, MED
,
MED
+
, HIGH
)
Five patterns are displayed, but LOW
+
is equal
to LOW
, and MED
+
to MED
.
(A receiving beep is heard.)
6
Auto louver button (SWING)
Push this button to swing the louver.
(A receiving beep is heard.)
Push the SWING button to stop the louver swinging.
(A receiving beep is heard.)
7
Set louver button (FIX)
Push this button to adjust the airflow direction.
(A receiving beep is heard.) It cannot be operated by
holding down the button. Push the button with some
interval.
8
Off timer button (OFF)
Push this button to set the OFF timer.
9
On timer button (ON)
Push this button to set the ON timer.
10
Reserve button (SET)
Push this button to reserve time settings.
(A receiving beep is heard.)
11
Cancel button (CLR)
Push this button to cancel ON timer and OFF timer.
(A receiving beep is heard.)
12
High power button (Hi-POWER)
Push this button to start the high power operation.
13
PRESET button
Push this button to change the operation mode to the
preferred operation mode memorized previously. To
memorize the operation mode, push this button for at
least 3 seconds during the preferred operation
mode.
is displayed and the operation mode is
memorized.
14
SLEEP button
Push this button to start the OFF timer operation that
automatically adjusts the room temperature and the
fan speed.
You can select the OFF timer time from four
durations (1, 3, 5 or 9 hours).
13
14
9
6
16
2
7
5
4
3
15
12
11
8
10
1
... The set temperature is increased up to 30 °C.
... The set temperature is dropped down to 17
°C. (A receiving beep is heard.)
TEMP
TEMP
TEMP
4-EN
+00EB01700201.BOOK Page 4 Wednesday, September 28, 2011 10:22 AM
