Toshiba Strata CT, Installation & Maintenance Manual

Page: 237 / 385

Peripheral Installation
Strata CT I&M Manual October 2000
6-49
Built-in Auto Attendant Installation
The built-in Auto Attendant feature only requires the installation of a feature key and
customer-supplied announcement devices to deliver announcements to callers. The feature
does not require the installation of any other devices.
➤
To install the customer-supplied digital announcement devices
Note
In Figure 6-25 and elsewhere in this manual, announcement devices are referred to
as A1 and A2. A1 designates a primary announcement device, and A2 a secondary
announcement device. The prime marks following the designation distinguishes the
multiple announcers from each other.
1. Ensure that the PCB that will connect with the device is installed per:
Chapter 3 – Universal Slot PCBs for the PSTU/RSTU
2. Connect the devices to the selected circuit per wiring diagrams:
◆
Chapter 4 – Universal Slot PCB Wiring
3. Ensure that the feature key is correctly installed per:
◆
Chapter 2 – Strata CT Installation , see BRCS on the BCU and RKYS installation
4. Program the system per the instructions in “Built-in Auto Attendant Basic Call
Sequences” on Page 6-47 .
5. Record the message and dialling prompts on the announcement device per the device
manufacturer's instructions.
Figure 6-25 Announcement Device Block Diagram
To Standard Telephone Circuit
MDF
Digital
Announcer
Digital
Announcer
Digital
Announcer
Digital
Announcer
Digital
Announcer
Digital
Announcer
Digital
Announcer
Digital
Announcer
To Standard Telephone Circuit
To Standard Telephone Circuit
To Standard Telephone Circuit
To Standard Telephone Circuit
To Standard Telephone Circuit
To Standard Telephone Circuit
To Standard Telephone Circuit
See Programs 23 and 24 for Digital Announcement Assignements
Primary Auto Attendant (AA) Announcements (A1, A1', A1'', A1''')
Secondary AA Announcements (A2, A2', A2'', A2''')
4308
A1
A2
A1'
A2'
A1''
A2''
A1'''
A2'''
Strata CT
RSTU or
PSTU
H
C