Toshiba Strata AirLink DK40i, Installation And Maintenance Manual

Page: 574 / 724

Peripheral Installation
PC/Data Communications Interface Units
12-66
Strata DK I&M 6/00
➤
To terminate the call
➤
Press the DKT’s
'DWD5HOHDVH
button.
...or
1. Type
XXX
from either PC keyboard. The PC screen displays,
OK
.
XXX
= PDIU-DI escape sequence (see “PDIU-DS to Modem Installation” on Page 12-62 ).
2. Type
ATH
from the PC keyboard used in Step 3 .
PC 1 and PC 2 screens display,
NO CARRIER
. The data call LEDs on each DKT are Off.
Figure 12-34 DK PC to PC Test Call Using AT Commands
PC-to-Printer Test using Manual Dialing
Note
See Figure 12-35 for additional information.
1. Set the RPCI or DIU programming.
♦ Program 20: Port 001. LEDs 01, 02, 05, and 17 On; all other LEDs Off.
♦ Program 20: Port 003. LEDs 01, 04, and 17 On; all other LEDs Off.
♦ Program 39: Port 001.
'DWD&DOO
(456) and
'DWD5HOHDVH
(454) buttons should be
provided.
♦ Default settings for PDIU-DI, S-Registers.
2. Make sure the PC is configured to print data from its serial port (the PC COM port connected
to DKT/PDIU-DI or DKT/RPCI-DI port 001). This is normally accomplished using the DOS
MODE commands.
Digital
(Port 000)
Digital
(Port 001)
Portable PC 1
RS-232
DKT/RPCI-DI or
DKT/PDIU-DI (200 )
MDF
MDF
RS-232
Portable PC 2
DKT/RPCI-DI or
DKT/PDIU-DI (201 )
Strata DK
1536