DISASSEMBLY INSTRUCTIONS
B1-1
1
Make the sort circuit
using a soldering.
Pick Up PCB
Deck Top Holder
(A)
2
2
3
2
4
DVD Deck
(C)
Front Angle
4
4
(B)
5
DVD Angle
1.
1-1:
REMOVAL OF MECHANICAL PARTS
AND P.C. BOARDS
TOP CABINET, FRONT CABINET, OPERATION 1/2
PCB AND FRONT JACK PCB (Refer to Fig. 1-1)
1.
2.
3.
4.
5.
6.
7.
8.
Remove the 5 screws
1
.
Remove the Top Cabinet in the direction of arrow (A).
Disconnect the following connectors:
(CP651 and CP652).
Unlock the 8 supports
2
.
Remove the Front Cabinet in the direction of arrow (B).
Remove the 11 screws
3
.
Remove the Operation 1/2 PCB and Front Jack PCB in
the direction of arrow (C).
Remove the 3 Pin Shield.
1-2: FLAP (Refer to Fig. 1-2)
1.
2.
Open Flap to 90˚ and flex in direction of arrow (A), at the
same time slide in direction of arrow (B).
Then lift in direction of arrow (C).
Fig. 1-2
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Make the short circuit on the position as shown Fig. 1-3
using a soldering. If you remove the DVD Deck with no
soldering, the Laser may be damaged.
Unlock the support
1
and remove the Deck Top Holder
in the direction of arrow (A).
Remove the 3 screws
2
.
Remove the screw
3
.
Disconnect the following connectors:
(CP2601, CP2602 and CP2603).
Remove the DVD Deck in the direction of arrow (B).
Remove the 3 screws
4
.
Remove the Front Angle in the direction of arrow (C).
Remove the screw
5
.
Remove the DVD Angle.
Fig. 1-3
1-3: DVD DECK (Refer to Fig. 1-3)
NOTE
When the installation of the DVD Deck, remove all the
soldering on the short circuit position after the connection of
Pick Up PCB and DVD PCB connector.
Fig. 1-1
1
1
2
Top Cabinet
1
1
1
(A)
(A)
Flap
(B)
(C)
2
2
2
2
2
(B)
2
(C)
3
Operation 1 PCB
3 Pin Shield
Front Jack PCB
3
3
3
3
3
3
33
3
3
2
Front Cabinet
Operation 2 PCB
