13
Introduction
Operation
• Aim the remote control at the remote sensor and press control buttons to
operate.
• Operate the remote control within 30° angle on either side of the remote
sensor, up to a distance of Approx. 7 meters.
Replace the compartment
cover.
Install two “R03/AAA” batteries
(supplied), paying attention to the
polarity diagram in the battery
compartment.
Slide the battery compartment
cover in the direction of the
arrow.
Approx. 7 meters
Battery precautions
The precautions below should be followed when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Re-
versed batteries may cause damage to the device. To avoid a potential short circuit, insert the “–” end first.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury from
possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and rupture. (Follow battery
manufacturer’s directions.)
• Press
POWER (
)
to turn the DVD VCR on or off.
• Select your desired operating mode (DVD or VCR) using
VCR DVD
.
(DVD or VCR indicator on the front panel will show you which mode is selected.)
• Press
CH +
or
CH
– to move through the channels one channel at a time.
• The
CH
+/
–
(
/
)
and
SET +/– (
/
)
are also used to navigate on-screen menu system.
• You can directly access specific channels using
Number buttons
.
• Each press of
VCR DVD
on the remote control, switches the screen between the VCR screen (VCR mode) and the
DVD screen (DVD mode).
1
2
3
Remote control basics
Inserting batteries
J2D8
1
701A (E)p02-13.p65 28/5/04, 1:39 PM
13
